Decoration Mount

Decoration Mount
Games:	LittleBigPlanet 3
Type:	Gameplay Kits
Category:	Decorative
Inputs:	3
Obtained from:	Start

This article is a tad short. A stub, if you will. You can help the Imagisphere Knowledge Base by expanding it with more information!

The Decoration Mount is an animated object that squashes and stretches any decorations placed on it in any axis.

Tweaks

Properties

Position in Layer: (-10 - 0 - 10) Sets where the Decoration Mount is located within its layer.

Left/Right

Minimum X-Axis Scale: (0% - 400%) Sets the minimum left/right size of the Decoration Mount.

Maximum X-Axis Scale: (0% - 400%) Sets the maximum left/right size of the Decoration Mount.

Up/Down

Minimum Y-Axis Scale: (0% - 400%) Sets the minimum up/down size of the Decoration Mount.

Maximum Y-Axis Scale: (0% - 400%) Sets the maximum up/down size of the Decoration Mount.

In/Out

Minimum Z-Axis Scale: (0% - 400%) Sets the minimum in/out size of the Decoration Mount.

Maximum Z-Axis Scale: (0% - 400%) Sets the maximum in/out size of the Decoration Mount.

Timing

Time: (0.0s - 86,400.0s) Determines the amount of time it takes for the Decoration Mount to grow and shrink.

Pause: (0.0s - 86,400.0s) Determines the amount of time the Decoration Mount will pause between its scaling cycles.

Sync: (0.0s - 86,400.0s) Determines the time offset of the Decoration Mount to everything else in the level.

Behaviour

Input Action: ( Start/Stop •‎ Forwards/Backwards •‎ Single Cycle •‎ Speed Scale •‎ Positional ) Determines how the Decoration Mount responds to the signal it receives through its inputs.

Scale From Top: ( No •‎ Yes ) If set to Yes, the Decoration Mount will be anchored to the top of its outline when scaling.